Home Whiting Kit

د.إ250

How to use

Step 1:

Place the tray over the upper teeth without placing the tray in boiling water. Practice with your tongue on

the roof of your mouth and touching the inside of the tray. Suck the air from the tray. This contours the guard

to the inside surface of the teeth. When finished repeat with the lower tray.

Step 2:

Bring water to a boil. The bowl should be at least 4″ deep to ensure the tray’s full immersion. Remove the

container from the heat and place one tray in the hot but not boiling water. Leave the tray in water for 5 seconds. Make sure the edges do not fold onto each other.

Step 3:

Lift the tray vertically from the water using the tab. carefully and quickly place the tray around the teeth and then immediately perform the procedure outlined in step 1.

Step 4:

Once you are satisfied with the fit, trim the front tab away from the tray with scissors. Make sure it is

flush with the front surface of the tray.

Step 5:

Place a small bead of gel per tooth in the inside of the tray (.5cc or less per tray). The gel might irritate

the gums if the trays are overloaded. Insert the trays very carefully keeping the gel on the teeth and away from

the gums.

Step 6:

Wear the trays for 15 minutes. If sensitivity or irritation occurs wait 24 hours between treatments and use

less gel. Be sure to rinse trays thoroughly after use. Repeat process daily until you reach the desired shade.

Final Step:

After completing the bleaching process it is always a good idea to take a toothbrush and gently wipe away any excess gel that remains on the teeth and gums to prevent any possible irritation. rinse excess gel from your toothbrush completely
——————————————————–
4 pieces 3 cc peroxide or non-peroxide gel (another option3 pieces 3 cc peroxide or non-peroxide gel, 1 pc Desensitization gel,)
1 pc 6 bulb white light
1 pc mouth tray box
2 pc mouth tray
1 PC manual book

Category:
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Home Whiting Kit”

Your email address will not be published. Required fields are marked *